I am planning on attempting to get my Apex tip inside my Lapco fake suppressor. The outter diameter of both are almost identicle so my plan is to sand / file down the od of the Apex so that it will slide snug into the suppressor. Anyone know of any reason not to attempt this?

The front tip of the suppressor will extend slightly past the opening of the Apex and is almost the same size opening as the Apex. Might that cause me problems with paintballs coming into contact with the suppressor as they leave the Apex? I could just reverse the suppressor if that is the case and have the front, more enclosed end in the rear and the full opening at the front.

__________________

Polished Internals-Super RT-Full Cyclone Upgrades-RedHot Power Tube-Red Dot-8"Brass-Lapco Suppressor-Apex-MP5 Mag-AirHOg Grip-UMS Bottom & Top Rails-Aluminum Cocking Rod & Grip-MP5 Stock-Remote HPA-Staubli Quick Release.