4.) Now that you have a clean and fresh operating surface it needs to be lubricated. I use WD-40 mainly to clean up the surface of any dirt that may be left; this also gives the surface lubrication…

**NOTE- WD-40 is NOT a substitute for regular marker oil. You should ONLY use the WD-40 to clean the surfaces. Upon reassembly oil the parts as you normally would during the reassembly process.



5.) Take a paper towel and fold it in half, then in half again. Spray the paper towel with a bit of WD-40…



6.) Rub the internal surface with the towel in a front-back type motion just as you did when scrubbing with the Brillo pad…



7.) Now you should have a nice smooth and clean operating surface…

__________________