Sand Paper – 800, 1000, (2000 for maximum smoothness)
Scissors
WD-40
Paper Towels
Time (The more time you take with this the better)
1.) Gather up your sheets of sand paper and fold them in half…
2.)Cut the sheet in half, then fold in half again and cut…
3.) This is where you must pay attention. First start out with your 800 grit, fold the smaller piece in half if you must and conform the paper to the inside of the receivers. DO NOT APPLY HARD PRESSURE. You simply need to use the 800 grit paper to cut down the overspray build up. Follow the forward to back motion as though the bolt was installed while sanding. You will sand the Rear and Front bolt surfaces. If you wish you can sand the area where the power tube also sets, but is not needed…
