I just ordered the egrip APE-preinstalled package drop in solution from tippmann pros. I do not have an expansion chamber and i do not use compressed air. will i see problems with freezes or whatever just using regular co2 with the e-grip?

also, i'm not modifying the cyclone yet either because i cannot afford it. is this APE egrip going to cause problems with the stock cyclone system? should I keep it around 15bps or less so i don't get a milkshake in my cyclone?

thanks in advance!

Well, I think you'll be fine with CO2. Don't quote me on that though because I have a WAS egrip. I don't see why it would be any different though.

As for the cyclone, I would keep it at least 17bps or lower. Try it out first though, if you start choppin paint go to 15 bps.

__________________

If you set your ROF too high, you may see some freezing. Being that it is summer time, the warmer weather may help prevent that a little. I would say the max you should set you ROF is around 15bps until you get either an expanshion chamber or a stablizer. I would recommend from my research getting the Palmers Stabilzer, from what I've read up on, it does a much better job then an expansion chamber.

__________________
What do you mean I can't use a Ref as a bunker?

awesome thanks guys!

Also, keep an eye on your Cyclone ratchet. That is one piece that can and will wear much faster with an e-grip or R/T. If your Cyclone stops working, take it apart and check the ratchet for wear. If it is chipped or cracked even just a little bit, replace it. Unfortunately the ratchet is prone to breaking, so your best bet here is to get a TechT Vortex or JCS Jet Click to replace it permanently.

__________________

Shhhh! You got shot by a GIRL!
TEAM VEGAS FIRE SQUAD