Looks great!

__________________
I have everything but a target...
Remember washer first, then Oring....Tombstone holds them in place

The Doglegs of War would be honoured to accept you as an official member, and the first we know to have a left-handed Dogleg. [

You can still run the airline direct to the tombstone, you just have to drill out your left receiver half and get one of these.

AirH0g sells something similar, you could PM him about it.

__________________

thank you for the invite and I will gladly accept!

that tombstone from specops looks good, i have no experience with milling so i have to find someone to do that for me if i do decide to go on with it. i plan to do it since my line does bend quite a bit

Nice setup there Merelye.

I know you had fun tracking down that LH Dogleg stock.

Welcome to the club, and some

__________________

It's not that hard a mod to do for the SpecOps version. You could probably do it with a hand file (round one) given a bit of time and patience. Here's a picture of how it should look (credits to Jaron for the pic)



The AirH0g version is designed to be flush with the receiver and thus requires removing the entire housing section of the tombstone. A bit trickier, but I know that Twigz(?) has done it with a hand file.

__________________