a-5 pins that hold cyclone

lobocharlie · #21 (**permalink**) 11-25-2008, 03:32 AM

Thank everyone for you help and Ideas. One thing I did notice is the prongs are tapered bigger on the bottom then the top . Your pin need to be tapered when it goes into the cyclone?

TAG · #22 (**permalink**) 11-25-2008, 04:30 AM

That's why I'm planning on only going 1/4" - that should be plenty of length without having to worry about taper.

--TAG--

lobocharlie · #23 (**permalink**) 11-25-2008, 02:55 PM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode