does anyone else have problems with the barrel seating not going in tightly. mine is older so it doesnt have the oring on it but it sat snug when i bought it.

I would go to a hardware store and buy an o-ring or order one through tippmann parts. I always ask this....are the "wings" on it horizontal or vertial?

__________________

The easy way to fix the position of the barrel adapter is to loosen off the front screws closest to the barrel adapter, then twist the barrel adapter as far clockwise as it'll go. It'll stop when it's in the right position, then you just retighten the screws.

And yes i'd grab an o-ring for it if I were you. Makes for a more snug fit.

__________________

I had my A5 barrel adapter and a Lapco autococker-A5 adapter modded to accept dual orings for extra stability. I found 1 oring isnt enough since the adapter ends up pivoting around that single oring. The dual orings drastically help.

__________________
SilentDeath12886's Compilation of A-5 Projectshttp://www.a5og.net/5-photo-gallery/...tml#post125307
The E-bolted A-5http://www.a5og.net/5-mods-upgrades/...tml#post108414
The X7 egrip retrofitted A-5 http://www.a5og.net/5-mods-upgrades/...tml#post122941
The old A-5 http://www.a5og.net/showthread.php?t=5009
The 98c backuphttp://www.a5og.net/showthread.php?t=5893

good idea i tink i might have to add one to my barrel adapter too....

__________________
Proud Canadian Baller
Kit: A5, camo job, polished internals, 14" Smart Parts Progressive barrel. Borrowed Opsgear G36 stock. 24oz CO2 w/ remote and slide check. Neat homemade sling. MORE TO COME
Vents Goggles and Multicam